![]() ![]() Hub Configuration /system identityĪdd address=192.168.255.1 interface=LoopbackĪdd exchange-mode=ike2 name=DynamicIP passive=yes send-initial-contact=noĪdd generate-policy=port-override my-id=fqdn: peer=DynamicIP \ The device has a USB 2. ![]() The policies on the HUB Router are automatically generated from the Spokes’ policies. It is affordable, small, and easy to use, but at the same time comes with a very powerful dual core 880 MHz CPU and 256 MB RAM, capable of the advanced configurations that RouterOS supports. This post is similar to this one, based on Juniper SRX. This is the relevant configuration I adopted, based on IKEv2 (PSK authentication). I had to create a configuration for Site-to-Site VPN using Mikrotik, with a Hub location (with static/public IP address) and some Spoke locations with dynamic IP addresses, and some of them behind NAT. ![]() Location: PPP Interface Configure provider setting for Internet connection. Mikrotik Site-to-Site VPN with dynamic peers (IKEv2) Required Setting on MikroTik Winbox PPPoE Connection setting. ![]()
0 Comments
Leave a Reply. |